Question 1

How do I switch between Single Motor and Dual Motor mode on the S10-SZ?

Accepted Answer

The Joyor S10-SZ (S10S-Z) features a dedicated toggle button located on the left handlebar assembly. Pressing the button engages or disengages the front 500W motor, allowing you to seamlessly switch between single-rear-drive and dual-drive mode (up to 2000W peak acceleration).

Question 2

Why is my display throwing an E-05 error even though the battery indicator shows full?

Accepted Answer

An E-05 code indicates controller undervoltage protection. If your battery is fully charged, this usually happens because the P03 parameter was accidentally changed. Access P-Settings and verify that P03 is set strictly to 60 for the S10-SZ.

Question 3

How do I switch the speed unit from km/h to mph?

Accepted Answer

Power on the display, press and hold Power and Mode buttons for 3 seconds to enter P-Settings. Toggle to P02, change the value from 0 (km/h) to 1 (mph), then hold both buttons to save.

Question 4

How can I reset all P-Settings back to factory defaults?

Accepted Answer

Enter the P-Setting menu, navigate to parameter P99, and hold the Mode button for 5 seconds until the screen flashes. After resetting, ensure P03 is manually confirmed at 60.

Question 5

What should I do if my S10-SZ shows dual-drive error codes E-11 or E-13?

Accepted Answer

Codes E-11 and E-13 are specific to the front motor drive system. Power off the scooter and inspect the quick-connect waterproof cable at the front hub. If persistent, contact official support for front controller/sensor replacement.

Category: Uncategorized